SynView IP Config Tool

Factory IP and System Settings

Requirements

It is mandatory to have iAMGigEServer running on iam system to use the SynView IP Config Tool.
Installation of the latest version of SynView to host system. See Download latest SynView Package for download link.
During production the latest version of the SynView Explorer and iAMGigEServer is installed to camera. Only in special cases it is necessary to update the camera. See section SynView Update Tool for detailed information.

After installation of latest Synview Prerelease the SynView IP Config Tool sv.ipconf.x64 can be found on your host-pc under the location:

C:\Program Files\SynView\bin\sv.ipconf.x64.exe

Change IP Address

The IP Address of iam camera is an important settings affecting the major interface and will therefore define the accessibility of the system.

This important feature can be set by the SynView IP Config Tool even if you Network Controller Configuration is not set properly.

iam operates with static ip settings du to the GenICam - Standard conformity

The IP address can be changed temporary and persistent. For changing the persistent IP address it is mandatory to have proper access to the system, eg. by change the IP address temporary first.

Temporary Change of IP Settings

Open sv.ipconf.x64.exe.
Now you should see the iam camera under "device model" even if the camera is not in the correct subnet.
Enter below “Current IP settings” or “Restart IP configuration” for obtaining the persistent settings.
Press button "Force IP address".

Temporary Change of IP Settings will be undo after reboot.

Persistent Change of IP Settings

Open sv.ipconf.x64.exe.
Now you should see the iam camera under "device model".
Press button "Connect and configure".
Enter below checkbox “Persistent IP address”
Press button "Use current IP address".
Press button "Apply and disconnect".

Persistent Change of IP Settings