Change IP System Settings of iam

Configuring the Network Controller

Connecting to the Camera

The camera is designed to be remotely controlled over OpenSSH.

The ping terminal command can be applied to see if the camera has booted:

Open

IP Address Settings

Mac / Linux

Open

Windows 10

1. Open the Windows10 start menu by pressing the Windows key on the keyboard. Type the words Control Panel and press enter.

2. Click the link titled View network status and tasks under the Network and Internet heading.

3. Click the link on the left of the window labeled Change adapter settings.

4. Right click on network adapter and choose properties to open the properties window.

5. Find the option of Internet Protocol Version 4 (TCP/IPv4) and click on it. Then choose option Properties , e.g. as shown below.

Configure the Network Controller Settings

Jumbo frames

Windows: Activating jumbo frames

Follow steps 1 to 4 in the section above.

1. property window: Click on Configure.
   
   

2. Select the second tab Advanced in the new window.

3. Look for the property Jumbo Packets

4. Select the highest value, e.g. 9014 Bytes
   
   

    

5. Confirm with OK

Interrupt Moderation

Windows: Disable Interrupt Moderation

For disable this feature follow the Steps 1. to 4. from the section above.

1. From the property window click on Configure

    

2. Select the second tab from the new window Advanced

3. Look for the property Interrupt Moderation

4. Select the Disable
   
   

Other features and options

related content

• IEEE 802.3 ETHERNET

• Wikipedia: jumbo frames