Versions Compared

Old Version 4

changes.mady.by.user Günter Dengler | NET GmbH

Saved on

compared with

New Version 5

changes.mady.by.user Günter Dengler | NET GmbH

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Expand
title1. Connect the camera to be tested - Start Synview Explorer on your Host System. iam camera should apear in the list of found cameras - if not check previus previous section. Select it in the and press the Connect camera button
Image RemovedImage Added

Expand
title2. Configure the camera features as desired. Pay attention especially to features in Image Format Control and Acquisition Control categories.
Image RemovedImage Added

Expand
title3. When prepared, click the Start acquisition button – the camera should start acquiring. If not, verify again, if the camera was not set to triggered mode, while no trigger was attached.
Image RemovedImage Added

Expand
title4. While the acquisition is active, you can still adjust the runtime parameters, such as exposure time or gain – but basic acquisition parameters, such as pixel format or trigger mode become locked when the acquisition starts.
Image RemovedImage Added

Expand
title5. When finished, click the Stop acquisition button and exit.
SynviewExplorer_aquision_stopImage RemovedSynviewExplorer_aquision_stopImage Added
Info

If you want to learn more about Synview Explorer skip next section and read through section “Getting started with Synview Explorer - and become ready to try Option 2.” first.