Configure your Network Controller

Configure your Network Controller depens on your operation system (OS)

In case of using a virtual guest system you need to configure only your Host Network Controller!

Mac / Linux

Under Linux and Mac on can use the same physical netzwork controller with multible virtuall controller settings - therefore it is not nessasary to change your current network setting - just add a new virtual controller instead.

Windows 10

Open the Windows 10 start menu by pressing the windows key on your keyboard. This time type the words Control Panel and press enter.
Click the link titled View network status and tasks under the Network and Internet heading.
Click the link on the left of the window labeled Change adapter settings.
Right click on your network adapter and choose properties to open up the properties window
Find the option of Internet Protocol Version 4 (TCP/IPv4) and click on it. Then choose the option under that titled Properties for example as shown below

You should test the connection by the ping command. First on your host system and in case of using a virtual guest system than inside the virtual maschine.

Connecto to Camera

The Camera is designed to be remote controlled over Openssh.

After power up it will take some time while the linux system is booting before the camera will respons.

On can use the ping terminal comand to see if the camera has booted:

If you do not have a linux or mac host system available NET provides a virtual machine image. How to set up the virtual machine is described in section Application Development / Virtual Host System below. You also can follow the steps of section Communicate with iam over windows host - without the virtual machine.