Connector and cable description
Ethernet connector
All the grounds from individual connectors are connected inside the camera. |
I/O Connector and Pinout
17-pin male M12 connector for digital i/o (optocoupler and TTL inputs/outputs) and power input.
CORSIGHT I/O connector TFM-107-02-L-DH.pdf | CORSIGHT I/O adapter cable, D-sub 25-pin connector SFSD-07-XXX-G-XX.XX-SR |
|---|---|
 |  |
Pinout (including pin numbers on the D-sub-25 adapter cable)
If the camera serial number has an X or Y in the 9th digit (e.g. 14A2GEBAX2042013) the I/O connector has the Prototype pinout!
Pin # | Schematic Name | Signal | D-Sub 25 |
|---|---|---|---|
1 | AUX_POWER | Power In- | 12 |
2 | GND_P | Power In+ | 19 |
3 | IN_TRIGGER+ | Optocoupler Input 3 Anode | 7 |
4 | IN_TRIGGER- | Ground | 5 |
5 | IN_ENC1+ | Optocoupler Output 1-3 Collector | 10 |
6 | IN_ENC2+ | Optocoupler Output 0 Emitter | 9 |
7 | IN_ENC3+ | Optocoupler Output 1 Emitter | 11 |
8 | IN_ENC_COM | Optocoupler Output 3 Emitter | 24 |
9 | OUT_GP1+ | TTL Input | 21 |
10 | OUT_GP2+ | TTL Output | 20 |
11 | OUT_GP_COM | Optocoupler Input 2 Anode | 6 |
12 | OUT_STROBE+ | Optocoupler Input 0 Cathode | 2 |
13 | OUT_STROBE- | Optocoupler Input 0 Anode | 1 |
14 | SGND_IO | Optocoupler Output 0 Collector | 8 |
15 | Optocoupler Output 2 Emitter | 25 | |
16 | Optocoupler 1 Input Anode | 3 | |
17 | Optocoupler 1-3 Input Cathode | 4 |
Pins 13, 14, 15, 16, 17, 18, 22, 23 on the D-sub 25 connector are not connected.
Cable Assembly
An adapter cable is available (see Section “Accessories”), with D-sub 25-pin female interface connector. The table below lists the pinouts also for the connectors of the adapter cable. This cable is fully shielded.