Power supply
DC power input
iam cameras are designed for power supply input range of 24 V ±10%. The power consumption depends on the utilisation of the main system parts: image sensor, FPGA, ARM cors. The power consumption is typically less than 13 W. A suitable power supply for iam is available from NET.
The customers designing an own power supply will find the information about the power input connector in Section “I/O connector”.
Power over Ethernet (PoE)
So far Power over Ethernet is not supported even though the camera will be detected as a PoE device by a PoE injector! See also Known Issues .
The iam cameras can be also powered using the Power over Ethernet option. The cameras are compatible with the Power over Ethernet standard, versions IEEE 802.3af and 802.3at. They should be used with PoE switches (“endspans”) or power injectors (“midspans”) complying with the IEEE 802.3af/IEEE 802.3at specifications.
The iam camera models are classified in the power level class 0 or class 3. The power consumption with PoE is slightly higher than consumption with “regular” power supply. When connecting multiple iam cameras to a single PoE switch, verify, how much total power the switch can provide and how it handles cases when the limit is exceeded.
Both PoE modes (A and B) are supported by the camera.
Beware of using the PoE cameras with 100Mbit Ethernet only cables, where the “spare” wire pairs might be omitted. With such cable, the power wouldn't be delivered when using Mode B compatible power sourcing equipment.