Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 13 Current »

Starting the SynView Explorer for the first time

Since the iAMGigEServer is pre-installed to the camera´s autostart, software camera images can be received with GigE Vision.

iam should be run with the latest version of SynView Explorer. For this, the host system should be updated. The download link is at the end of section Download latest Synview Prerelease .

 1. Connect the camera for test: Start SynView Explorer on your host system. iam should appear in the list of found cameras. If not, check the previous section ("Configure your Network Controller"). Select it in the list of found cameras and press the "Connect camera" button.

 2. Configure the camera features as desired. Pay special attention to features in the categories "Image Format Control" and "Acquisition Control".

 3. When prepared, click the "Start acquisition" button to start acquiring images with the camera. If not, verify again, if the camera was set to triggered mode, and if a trigger was attached.

 4. While acquisition is active, you can still adjust the runtime parameters, such as exposure time or gain. Basic acquisition parameters, such as pixel format or trigger mode get locked when acquisition starts.

 5. When finished, click "Stop acquisition" button and exit.
SynviewExplorer_aquision_stop

To learn more about SynView Explorer skip to next section, read through section “Getting started with SynView Explorer”, and get ready to try Option 2.” first.

  • No labels

© Copyright 2020 NET GmbH. Privacy Statement