Introduction
With the release of Matrox Imaging Library (MIL) X, matrox now offers support for Arm processor architecture.
For more information about the MIL software, we refer to their website: https://www.matrox.com/en/imaging/products/software/sdk/mil
If you are interested in using Matrox Imaging Library (MIL) on iam camera please contact you sales.
Installation
tested with mil-full-10.42_281_arm64.tar.gz
To install the MIL software on an iam, following steps are necessary:
Copy mil-full-10.42_281_arm64.tar.gz to /home/root
use a OpenSSH connection
scp mil-full-10.42_281_arm64.tar.gz root@192.168.1.10:/home/root
Untar the file with following commands:
ssh root@192.168.1.10
tar -xvf mil-full-10.42_281_arm64.tar.gz -C /opt/ && source /opt/matrox_imaging/setup.sh
The MIL software will be installed to /opt/matrox_imaging . A reboot would be necessary for having the MIL software added to your PATH.
For the license, you can start milconfig, go to Licensing->Activate and enter the license key there. milconfig is in /opt/matrox_imaging/tools which should have been added to your PATH.
Usage
iAMGigEServer has to be stopped, if you are using MIL examples.
There are multiple examples which, are all under
/opt/matrox_imaging/mil/examples
Most of this examples need a graphical interface. Therefore start this examples with X-Server support:
See using X-Server on a Windows Host System
ssh -X root@192.168.1.10
Attachments
🔍 References
👥 contact NET