| Excerpt |
|---|
Change IP System Settings of iam
| Include Page | ||||
|---|---|---|---|---|
|
...
Configuring the Network Controller
...
The configuration of
...
your network controller depends on your
...
operating system (OS).
In case of using a virtual guest system configure only the host network controller!
| Note |
|---|
One can improve Improve the network performance considerably by configuring the network controller properly. See section “jumbo frames” and |
Connecting to the Camera
The Camera camera is designed to be remote remotely controlled over OpensshOpenSSH.
After power up it will take some time while the linux system is booting before the camera will responds.You need to configure your respond due to the booting of the Linux system.
Configure the network controller properly as described below before you can use using the ping command.
On can use the The ping terminal comand command can be applied to see if the camera has booted:
...
| Info |
|---|
If you do not have a linux or mac In abscence of a Linux or Mac host system available NET provides a virtual machine image. How to set up the virtual machine is described in section Application Development / Virtual Host System below. You See also can follow the steps of section Communicate with iam over windows host - without the virtual machine. |
...
Mac / Linux
| Info |
|---|
Under Linux and Mac on can use the same physical netzwork network controller with multible virtuall multiple virtual controller settings - therefore is applicable. Therefore it is not necessary to change your the current network setting - . Instead, just add a new virtual controller instead. |
...
Windows 10
Open the Windows 10 Windows10 start menu by pressing the windows Windows key on your the keyboard. This time type Type the words
Control Paneland press enter.Click the link titled
View network status and tasksunder theNetwork and Internetheading.Click the link on the left of the window labeled
Change adapter settings.Right click on your network adapter and choose
propertiesto open up the properties window.Find the option of
Internet Protocol Version 4 (TCP/IPv4)and click on it. Then choose the option under that titledPropertiesfor exampleProperties, e.g. as shown below.
...
You should test Test the connection by with the ping command . First first on your the host system and in case of than inside the virtual machine if using a virtual guest system than inside the virtual maschine.
Configure
...
the Network Controller Settings
Jumbo frames
| Info |
|---|
Jumbo frames are Ethernet frames with more than 1500 bytes of payload, the limit set by the IEEE 802.3 standard. In particular in the context of GigEVISION , GigE Vision jumbo frames can improve network performance massively since image data are tradionaly is originally high-volume data. |
Windows:
...
Activating jumbo frames
follow the Steps Follow steps 1 . to 4 . from in the section above.
From the
property windowclick : Click onConfigure.
From
the new window select Select the second tab
Advancedin the new window.Look for the Property property
Jumbo PacketsSelect the highest value, ege.g.
9014 Bytes
Confirm with
OK
...
| Info |
|---|
Interrupt Moderation is a feature that groups packets together and sends them as a batch. It can be responsible for sluggish behavior of the connection. For a continues continuous image data transmission this feature is not very useful. |
Windows: Disable
...
Interrupt Moderation
For diable disable this feature follow the Steps 1. to 4. from the section above.
From the
property windowclick onConfigureFrom
Select the second tab from the new window select the second tab
AdvancedLook for the Property property
Interrupt ModerationSelect the
Disable
...
Other features and options
There is a Helpful content: Blogpost about how to Optimizing Ethernet Adapter Settings for Maximum Performance (external link).
...