| Excerpt |
|---|
Accessories
Break-Out-Boards
...
Interface Break Out Boards
...
| Table of Contents | ||||
|---|---|---|---|---|
|
...
Pinout
| Excel | ||||
|---|---|---|---|---|
|
CBB1A R2 Break out Board
incl. DIN rail mount
| View file | ||
|---|---|---|
|
| View file | ||
|---|---|---|
|
...
075IOAD - Trigger, Strobe and IO Test Board
Trigger, Strobe and IO Test Board. Can be used to plug two iam cameras twisted crossed together (OUT → IN , IN ← OUR togetherOUT).
...
Dokumentation
| Attachments | ||||||
|---|---|---|---|---|---|---|
|
CBB1A R2 Break out box; incl. DIN rail mount
CBB1A2 cable
| Note |
|---|
This cable is not shielded against EMC emission. |
Wenn using this cable camera must be shielded against EMC emission by professionals according to local EMC provisions
...
CAM1: Primary Camera Connector
Can be fastened on backside of camera using 2x M2x6 srews (Bottom Side Connector J2) or by using discrete wire assembly from samtec SFSD-07-28-G-XX.XX-DR-NUS plugged into topside connecotr J1.
CAM2: Secondary Camera Connector
Secound iam camera can be connected crossed (OUT1 → IN2 , IN1 ← OUT2) by using discrete wire assembly from samtec SFSD-07-28-G-XX.XX-DR-NUS plugged into topside connecotr J3.
J3/J10 - AUX Power Supply
075IOAD can be powerd by 24V supply using J10 connector or J3 srew terminal. If J4 or J10 is used iam CAM1 is always powerd as well.
CAM2 can be powerd as well by jumping “CAM Power” on Terinal J13.
J11-12 - Jumper Terminals
With the Jumper Terminals J11 and J12 the camera IO-terminals can be supplied with AUX Power so additional components like LEDs and bush buttoms can be used.
See 075IOAD20_schematic.pdf for details.
...
Documentation
| Attachments | ||||||
|---|---|---|---|---|---|---|
|
Errata
Revision 2.0
J6 | silksreen labeling is wrong | TRIG+ is IN_TRIGGER- TRIG- is IN_TRIGGER+ | should be swaped |
D8, D9 | silksreen labeling is wrong | D9 belongs to IN_ENC1 (OUT_GP1) D8 belongs to IN_ENC2 (OUT_GP2) | should be swaped |
...