Versions Compared

Old Version 10

changes.mady.by.user Gregor Martin (Deactivated)

Saved on

compared with

New Version Current

changes.mady.by.user Benjamin Hoffmann (Unlicensed)

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Starting the

...

SynView Explorer for the first time

Info

Since the iAMGigEServer is preinstalled pre-installed to the camera´s autostart, software camera images can be received with GigE Vision.

Tip

iam should be run with the latest version of Synview SynView Explorer. For this, the host system should be updated. The download link is at the end of section Download latest Synview Prerelease .

Expand
title1. Connect the camera to be tested: start Synview for test: Start SynView Explorer on your host system. iam should apear appear in the list of found cameras. If not, check the previous section ("Configure your Network Controller"). Select it in the list of found cameras and press the "Connect camera" button.

...

Expand
title3. When prepared, click the "Start acquisition" button to start acquiring images with the camera acquiring imaages. If not, verify again, if the camera was set to triggered mode, and if a trigger was attached.

...

Expand
title5. When finished, click "Stop acquisition" button and exit.
SynviewExplorer_aquision_stop
Info

To learn more about Synview SynView Explorer skip to next section, read through section “Getting started with Synview ExplorerSynView Explorer”, and become get ready to try Option 2.” first.