| Excerpt |
|---|
...
Getting Started with Windows Host System
Introduction
Linux and
...
MacOSX supports openSSH with X-Server Forwarding nativ. In case of windows some special tool are required. In this section
...
an introduction is given.
Once you have configure your windows ethernet adapter you can test the settings with ping command:
| Code Block |
|---|
ping 192.168.1.10 |
System Requirements:
In order to view a live stream , for example with synview, you can use the tools listed below.
Install putty on your windows machine
putty will do the ssh-connection to the iam-camera.Install Xming
Xming will do the graphical interface on windowsInstall WinSCP is usefull on any host system
WinSCP is a program to transfer files from/to the iam camera.
The tools above for Win64 can be downloaded from below.
| Attachments | ||||
|---|---|---|---|---|
|
WinSCP - Filetransfer to camera:
| Info |
|---|
WinSCP is a program to transfer files from/to the iam camera: https://winscp.net/eng/docs/lang:de |
The configuration of WinSCP should look like follows:
...
The iam camera asks for a password.
| Tip |
|---|
The password is |
PuTTY and Xming - Open applications with graphical user interfaces:
Xming
For using X-Server forwarding on need to start the Xming Server first. You should have a link in your windows start menue.
| Tip |
|---|
After launching on should see the Xming Symbol |
If you start Xming the first time, you may get asked by the windows firewall to create an exception for Xming.
Configuration of putty:
Insert the iam ip address
192.168.1.10in "Session→Host name"
...
Configure "Connection->SSH→X11" as follows:
...
| Info |
|---|
A link to a configuration help page: http://www.geo.mtu.edu/geoschem/docs/putty_install.html |
If you connect to iam the first time you may get asket the following warning. You need to confirm with "yes".
...
After opening that connection, login as
| Tip |
|---|
User: Password: |
Start synview:
Type into console:
|
| Info |
|---|
It is an common sources of error to operate an monochrom sensor in the colour space. If you reviced an monochrome sensor you should change the |
Please be aware, that you get only a low frame refresh rate with this type of connection.
A better refresh rate will be achieved with the "GigEvision server of synview" in the future.
For more information see section Synview above.
Start halcon viewer from then test_halcon_samples:
| Info |
|---|
Halcon can be preinstalled to your camera. See Halcon fore more information. |
Type into console:
|
| Info |
|---|
"Image Format Control → Pixel Format" to Mono8 is set inside "test_halcon_live_view" |
For more information see section Halcon.
| Attachments | ||
|---|---|---|
|
...
🔍 References
👥 contact NET
...
...