| Excerpt | |
|---|---|
|
Introduction
With the release of Matrox Imaging Library (MIL) X, matrox now offers support for Arm ARM processor architecture.
For more information about the MIL software, we refer to their website: https://www.matrox.com/en/imaging/products/software/sdk/mil
| Info |
|---|
If you are interested in using Matrox Imaging Library (MIL) on iam camera please contact you sales. |
Installation
tested Tested with mil-full-10.42_281_arm64.tar.gz
To install the MIL software on an iam, following steps are necessary:
Copy mil-full-10.42_281_arm64.tar.gz to /home/root
| Info |
|---|
use Use a OpenSSH connection |
| Code Block |
|---|
scp mil-full-10.42_281_arm64.tar.gz root@192.168.1.10:/home/root |
Untar the file with following commands:
| Code Block |
|---|
ssh root@192.168.1.10
tar -xvf mil-full-10.42_281_arm64.tar.gz -C /opt/ && source /opt/matrox_imaging/setup.sh
|
The MIL software will be installed to /opt/matrox_imaging . A reboot would be necessary for having the MIL software added to your PATH.
For the license, you can start milconfig, go to Licensing->Activate and enter the license key there. milconfig is in /opt/matrox_imaging/tools which should have been added to your PATH.
Usage
| Info |
|---|
iAMGigEServer has to be stopped, if you are using MIL examples. |
There are multiple examples which, are all under
| Code Block |
|---|
/opt/matrox_imaging/mil/examples |
Most of this these examples need a graphical interface. Therefore start this these examples with X-Server support:
| Tip |
|---|
See using X-Server on a Windows Host System |
| Code Block |
|---|
ssh -X root@192.168.1.10 |
Attachments
| Attachments | ||||
|---|---|---|---|---|
|
🔍 References
👥 contact NET
| Insert excerpt | ||||||
|---|---|---|---|---|---|---|
|