| Excerpt |
|---|
| Info |
|---|
Configure your Network Controller depens on your operation system (OS) |
In case of using a virtual guest system you need to configure only your Host Network Controller!
| Note |
|---|
On can improve network performance massifly by configure your netzwork controller properly. See section “jumbo frames” and |
IP Adress Settings
Mac / Linux
| Info |
|---|
Under Linux and Mac on can use the same physical netzwork controller with multible virtuall controller settings - therefore it is not nessasary to change your current network setting - just add a new virtual controller instead. |
Windows 10
Open the Windows 10 start menu by pressing the windows key on your keyboard. This time type the words
Control Paneland press enter.Click the link titled
View network status and tasksunder theNetwork and Internetheading.Click the link on the left of the window labeled
Change adapter settings.Right click on your network adapter and choose
propertiesto open up the properties windowFind the option of
Internet Protocol Version 4 (TCP/IPv4)and click on it. Then choose the option under that titledPropertiesfor example as shown below
...
You should test the connection by the ping command. First on your host system and in case of using a virtual guest system than inside the virtual maschine.
Configure your Network Controller Settings
Jumbo frames
| Info |
|---|
Jumbo frames are Ethernet frames with more than 1500 bytes of payload, the limit set by the IEEE 802.3 standard. In particular in the context of GigEVISION jumbo frames can improve network performance massivly since image data are tradionaly high voloume data. |
activating jumbo frames on Windows
follow the Steps 1. to 4. from the section above.
From the
propertie windowclick onConfigure
From the new window select the secound tab
AdvancedLook for the Property
Jumbo PacketsSelect the highest value, eg.
9014 Bytes
Confirm with
OK Jumbo frames
Connecto to Camera
The Camera is designed to be remote controlled over Openssh.
After power up it will take some time while the linux system is booting before the camera will respons.
On can use the ping terminal comand to see if the camera has booted:
...
| Info |
|---|
If you do not have a linux or mac host system available NET provides a virtual machine image. How to set up the virtual machine is described in section Application Development / Virtual Host System below. You also can follow the steps of section Communicate with iam over windows host - without the virtual machine. |
🔍 References
🔗 related content
👥 contact NET
| Insert excerpt | ||||||
|---|---|---|---|---|---|---|
|