...
 | Connect the camera to be tested — select . Select it in the list of found cameras and press the Connect camera button. |
 | Configure the camera features as desired. Pay attention especially to features in Image Format Control and Acquisition Control categories. |
 | When prepared, click the Start acquisition button — the . The camera should start acquiring. If not, verify again, if the camera was not set to triggered mode, while no trigger was attached. |
 | While the acquisition is active, you can still adjust the runtime parameters can be adjusted, such as exposure time or gain. Basic acquisition parameters, such as pixel format or trigger mode become get locked when the acquisition starts. |
 | When finished, click the Stop acquisition button and exit. |
| Info |
|---|
It is an common sources source of error to operate an a monochrom sensor in the colour color space. If you reviced an In case of a monochrome sensor you should change the |
...
From the line just above the live image you can see , the current frames which arrived count per second on the iam camera system every secondis visible. Display Displaying the images remote over an OpenSSH connection will impair the performace a lot very much and will add some delay as well. In the example below, the sensor runs with 147 frames - per - second and 1.8 frames per secound where second if displayed remoteremotely.
...
| Tip |
|---|
See what your camera model can achieve by look looking up the maximum frame rate at Camera Model Overview table. |
| Info |
|---|
An OpenSSH session using live imaging has a poor performance but can help to change camera parameter parameters or test new features. |
| Info |
|---|
Please be aware , that you get only a of the low frame refresh rate with this type of connection. A better refresh rate will be achieved with the "GigE Vision server of synviewSynview" in the future. |
Basic camera features
...
The SynView Explorer displays by default only the “basic” camera features intended to handle the most common tasks. To display also the more advanced features, you need to switch to the “expert” feature level. Note that the third available level, “guru”, is intended just for debugging and should not be used for normal operation.
...