Starting the Synview Explorer for the first time

Info
Since the iAMGigE-server iAMGigEServer is preinstalled to cameras autostart. You can use the camera´s autostart, with GigEVision Software to recive camera images can be received.

Tip
For iam you need iam should be run with the latest version of Synview Explorer. Please update your Host System. You can find a download link For this, the host system should be updated. The download link is at the end of section Download latest Synview Prerelease .

Expand

title	1. Connect the camera to be tested - Start : start Synview Explorer on your Host Systemhost system. iam camera should apear in the list of found cameras - if . If not, check the previous section ("Configure your Network Controller"). Select it in the list of found cameras and press the "Connect camera" button.

Expand

title	2. Configure the camera features as desired. Pay special attention especially to features in the categories "Image Format Control" and "Acquisition Control categories".

Expand

title	3. When prepared, click the "Start acquisition" button – to start the camera should start acquiring imaages. If not, verify again, if the camera was not set to triggered mode, while no and if a trigger was attached.

Expand

title	4. While the acquisition is active, you can still adjust the runtime parameters, such as exposure time or gain – but basic . Basic acquisition parameters, such as pixel format or trigger mode become get locked when the acquisition starts.

Expand

title	5. When finished, click the "Stop acquisition" button and exit.

Info
If you want to learn more about Synview Explorer skip next section and read through section “Getting started with Synview Explorer - and become ready to try Option 2.” first.

...

Versions Compared