| Excerpt |
|---|
Connector and cable description
...
Ethernet connector
| iam is equipped with a standard Ethernet connector, 8P8C modular plug, often also referred to RJ-45All the grounds from individual connectors are connected inside the camera. |
...
I/O Connector and Pinout
1417-pin DLP (dual-inline-pin) male M12 connector for digital I/O i/o (optocoupler and TTL inputs/outputs) and power input. An adapter cable is available (see Section “Accessories”).
...
.
CORSIGHT I/O connector TFM-107-02-L-DH.pdf | Mates Pinnout CORSIGHT I/O adapter cable, D-sub 25-pin connector SFSD-07-XXX-G-XX.XX-SR |
|---|---|
 |  |
Pinout (including pin numbers on the D-sub-25 adapter cable)
If the camera serial number has an X or Y in the 9th digit (e.g. 14A2GEBAX2042013) the I/O connector has the Prototype pinout!
Pin # | Schematic Name | note | Prototype pinout (s. note above) s. Known Issues | Signal | D-Sub 25 |
|---|---|---|---|---|---|
1 | AUX_POWERauxiliary power supply voltage | Power In- | 12 | ||
2 | GND_P | auxiliary power supply groundPower In+ | 19 | ||
3 | IN_TRIGGER+ | Optocoupler Input TRIGGER 3 Anode | 7 | ||
4 | IN_TRIGGER-Optocoupler Input | TRIGGER CathodeGround | 5 | ||
5 | IN_ENC1+ | Optocoupler Input Output 1 Cathode | Optocoupler Input 1 Anode-3 Collector | 10 | |
6 | IN_ENC2+ | Optocoupler Input 2 Cathode | Optocoupler Input 2 AnodeOutput 0 Emitter | 9 | |
7 | IN_ENC3+ | Optocoupler Input 3 Cathode | Optocoupler Input 3 AnodeOutput 1 Emitter | 11 | |
8 | IN_ENC_COM | Optocoupler 1-Output 3 Input Anode | Optocoupler 1-3 Input CathodeEmitter | 24 | |
9 | OUT_GP1+ | Optocoupler Output 1 Collector | Out of order (Always on!)TTL Input | 21 | |
10 | OUT_GP2+ | Optocoupler TTL Output 2 Collector | 20 | ||
11 | OUT_GP_COM | Optocoupler Output 1-2 EmitterInput 2 Anode | 6 | ||
12 | OUT_STROBE+ | Optocoupler Output STROBE CollectorInput 0 Cathode | 2 | ||
13 | OUT_STROBE- | Optocoupler Output STROBE EmitterInput 0 Anode | 1 | ||
14 | SGND_IOCable Shield | Optocoupler Output 0 Collector | 8 | ||
15 | Optocoupler Output 2 Emitter | 25 | |||
16 | Optocoupler 1 Input Anode | 3 | |||
17 | Optocoupler 1-3 Input Cathode | 4 |
Pins 13, 14, 15, 16, 17, 18, 22, 23 on the D-sub 25 connector are not connected.
...
Cable Assembly
| Info |
|---|
An adapter cable is available (see Section “Accessories”), with D-sub 25-pin female interface connector. The table below lists the pinouts also for the connectors of the adapter cable. This cable is fully shielded. |
|