Software Tools and System Requirements

Hardware

• iam embeddes smart vision camera system

• PoE+ Injector (see Known Issues ) or beak-out-board with external power supply

• Netzwerk Cable (Class 6)

• Host PC System: Linux or Mac prefered if you do not have a linux system you should use the virtual machine image below.
  

Software

You can set up the camera in the three different ways

1. Use an Native Linux or Mac host

2. Using a Windows Machine as discribed in section Windows Host System

3. Use our Virtual Machine Disk image on any OS with Virtual Box as discribed in section Virtual Host System

Quick-Start Guide

The purpose of this guide is to obtain a live image from your iam camera using synview explorer. Synview is a software developed by net and is used both on iam camera and your host system. Therfore there are two options to steam a live image to your host system either

1. by usining the iAMGigE-Server on iam camera and synview explorer on your host system or

2. running synview explorer direct on iam camera and using openSSH with X-Server forwarting for display.

Option 1. is the more easy one and is as well preinstalled to your camera but option 2. is going to be more important, since it can be similar used with any GUI software. As well, option 2. will be often much quicker during more advanced operation and development process with your iam camera.

The figure below illustrates the two options for obtaining a live view image.

The guide is structured in the following section - by select “>” the sections content will expland.

• While the acquisition is active, you can still adjust the runtime parameters, such as exposure time or gain

• But basic acquisition parameters, such as pixel format or trigger mode become locked when the acquisition starts.

• When finished, click the Stop acquisition button and exit.

Expand
title Option 1: Stream live image to host using iAMGigEServer
Info Since the iAMGigE-server is preinstalled to cameras autostart. You can use GigEVision Software to recive camera images. Tip For iam you nee the latest version of Synview Explorer. Please update your Host System. On can find a download link at the end of section Synview .	Image Removed	Connect the camera to be tested Start Synview Explorer on your Host System. iam camera should apear in the list of found cameras - if not check previus section Configure your Network Controller select it in the and press the Connect camera button.	Image Removed	Configure the camera features as desired. Pay attention especially to features in Image Format Control and Acquisition Control categories.	Image Removed	When prepared, click the Start acquisition button the camera should start acquiring. If not, verify again, if the camera was not set to triggered mode, while no trigger was attached.	Image Removed	Image Removed
Info